Edmonton-based, serving all of AlbertaStamped electrical drawings in 48 hours
TriArc Engineering Get a quote

Services EV & fleet charging

EV & fleet charging engineering

Charger sizing, load management and service capacity.

About this service

Adding EV chargers usually comes down to one question: does the existing service have room? We answer that first, then design the charging around it.

We review service capacity using actual demand data where it's available, apply EV energy management under CEC Rule 8-500 where it avoids an expensive upgrade, and lay out chargers, circuits and distribution for fleet depots, condo parkades, commercial lots and dealerships.

Designs are planned for future expansion so adding chargers later doesn't mean starting over, and we coordinate with EPCOR or FortisAlberta when a service upgrade is the right answer.

What we design

Adding EV chargers usually comes down to one question: does the existing service have room? We review capacity, apply load management where it saves an upgrade, and lay out chargers for fleets, condos and commercial lots.

48 hfrom complete information to a stamped permit set on standard scopes
  • Service capacity review
  • EV energy management systems
  • Charger layout and circuits
  • Fleet depot design
  • Condo and multi-unit EV
  • Future expansion planning
EV charging electrical engineering project in Edmonton | TriArc Engineering

Typical projects

Fleet charging yard

Condo parkade EV

Commercial parking lot

Dealership chargers

Code basis & approvals

Designed for permit authorities across Alberta.

  • Canadian Electrical Code Section 86 and Rule 8-500
  • EPCOR or FortisAlberta service requirements
  • Municipal permits across Alberta

What you receive

Drawings your electrician can build from and your plans examiner can approve.

Sealed PDF drawing setPanel schedulesLoad calculationsSingle-line diagramSpecifications as requiredPermit support

EV charging for buildings and fleets

Adding EV chargers usually starts with one question: can the existing service handle it? We calculate the available capacity and, where it is limited, design electric vehicle energy management systems (EVEMS), which the Canadian Electrical Code permits, so more chargers can share the service you already have.

We design charging for commercial lots, fleet yards, condominiums and rental buildings in Edmonton and area, and coordinate with your installer and the utility when a service upgrade is needed.

We provide electrical engineering services in Edmonton, St. Albert, Sherwood Park, Spruce Grove, Stony Plain, Leduc, Beaumont and Fort Saskatchewan, and take on projects anywhere in Alberta. Start a project or call 780-919-9696.

Need ev & fleet charging drawings?

Send us what you have and we'll confirm scope and fee the same business day.

Start a project